Quantcast
Channel: YamahaMusicians.com
Viewing all articles
Browse latest Browse all 2726

Yamaha MOXF • Re: Issue in the performance mode in MOXF

$
0
0
Thank you for your reply,
Q: Can you tell us exactly the steps that you take, so that we can check if we can reproduce the issue?
A: The issue occurred out of a sudden, just after turning it on, the only thing can be mentioned is that MOXF was connected to Boss RC600 via 5pins midi cable.
I did factory reset from utility section as per manual, with no difference.
Also I copied this performance to pattern mode, to access insertion A and B, but issue persists even when change the effect assigned in the insertion bottom.
All trials done while connecting Yamaha monitors HS8 directly to the MOXF.
Q: Which performance did you select? I assume it was a factory performance, correct?
A: BleePad ,and many others which is one of the factory performances, yes

Q: How do you listen to the voice in part 4?
As per attached video, disable the first three voices,
Voice itself checked in voice mode, and found ok, issue disappeared when push bottom insertion, and also when insertion is disabled from switch mode for part 4, the strange sound is disappeared but with out the effect.

My gut feelings that this is an midi issue, error somewhere, not a configuration issue, midi panic

Thank you again
2023-12-24T23-30-03Z-1.mp4

Statistics: Posted by ShereefWagih — Sun Dec 24, 2023 9:36 pm



Viewing all articles
Browse latest Browse all 2726

Trending Articles