Hello everyone!
Today I wanted to try an MCD64 card to add some additional banks, however, when I inserted the card the TG500 got restarted and then got stuck in the boot screen, I tried the second slot and same result.
Somehow it occurred to me that maybe it has to do with the firmware, so I went ahead and installed back the original firmware v1.10 and the card worked fine.
Being hesitant about the firmware, I programmed another 27C4001 that I had, verified the firmware, and installed it in the TG500 and same result, thus, I'm wondering if I need an actual 27C040 or if is a problem with v1.20.
Any help will be much appreciated.
Today I wanted to try an MCD64 card to add some additional banks, however, when I inserted the card the TG500 got restarted and then got stuck in the boot screen, I tried the second slot and same result.
Somehow it occurred to me that maybe it has to do with the firmware, so I went ahead and installed back the original firmware v1.10 and the card worked fine.
Being hesitant about the firmware, I programmed another 27C4001 that I had, verified the firmware, and installed it in the TG500 and same result, thus, I'm wondering if I need an actual 27C040 or if is a problem with v1.20.
Any help will be much appreciated.
Statistics: Posted by manpaz — Sat Oct 26, 2024 4:14 am